Most jewellery needs nothing more than warm water, a little mild soap and a soft brush. The trick is knowing which pieces need even less.
If you want to know how to clean jewelry without damaging it, start with the gemstone, then the metal. Some stones shrug off almost any treatment, while others can crack, cloud or lose their filler in an ultrasonic cleaner. This guide sets out a gentle routine that works for many pieces, then goes stone by stone using GIA’s published care advice and metal by metal using the FTC Jewelry Guides and the Canadian Conservation Institute (CCI). For new pieces, browse our Amazon Jewelry roundup; for the metals in more depth, see How to Clean Sterling Silver Jewelry and Remove Tarnish and How to Clean Gold Jewelry Safely.
One rule sits above everything below: check the maker’s or jeweller’s care instructions for each piece. Treated stones, plated metal and antique settings can all need special handling, and no method here is guaranteed safe for every item.
What you need
- A small bowl of warm water
- Mild dish soap (fragrance-free and dye-free if possible)
- A soft brush, such as a soft toothbrush or a Soft Jewelry Cleaning Brush on Amazon
- Soft, lint-free cloths
- A silver polishing cloth for sterling pieces
- A sink stopper or a strainer, so nothing slips down the drain
The gentle default: warm soapy water
GIA names warm soapy water and a soft brush as the safe cleaning method for many gemstones, including emerald, tourmaline, moonstone, peridot, tanzanite and opal. It is also the common first step for plain metal pieces. Here is the routine:
- Close the sink drain or work over a bowl.
- Fill a bowl with warm (not hot) water.
- Add a drop or two of mild dish soap and stir.
- Dip the piece in the water for a short time. Skip soaking for pearls, opals and porous stones; wipe them instead.
- Brush gently with a soft brush, especially behind stones and around prongs where grime collects.
- Rinse in clean warm water.
- Pat dry with a lint-free cloth.
- Let the piece air-dry fully before storing it.
This simple jewelry cleaning solution of soap and water is the baseline. Many commercial cleaners exist, but read their labels carefully, since some are made for specific metals or stones only.
Ultrasonic and steam cleaners: GIA’s cautions
Ultrasonic cleaners use vibration in a liquid, and steam cleaners use heat and pressure. Both are popular, and both can damage certain stones. GIA’s guidance is specific:
| Stone | Ultrasonic | Steam | Note (per GIA) |
|---|---|---|---|
| Emerald | Never | Never | “Vibrations and heat can cause the filler to sweat out” |
| Opal | Never | Never | Use warm soapy water |
| Pearl | Never | Never | Wipe with a soft damp cloth after each wear |
| Moonstone | Never | Never | Use warm soapy water |
| Peridot | Never | Never | Use warm soapy water |
| Sardonyx | Never | Never | |
| Turquoise | Never | Never | Sensitive to heat, acids and chemicals |
| Tanzanite | Never | Never | Use warm soapy water |
| Zircon | Never | Never | |
| Garnet | Can be used | No | Fracture-filled garnets need extra care |
| Alexandrite | Generally safe | Generally safe | |
| Spinel | Generally safe | Generally safe |
Source: GIA birthstone care pages (January, May, June, August, October, December).
If you are not sure what a stone is, or whether it has been treated or filled, treat it as delicate and stick with soap and water. A jeweller can identify stones and treatments.
How to clean jewelry by stone
Pearls
Pearls are organic and soft. GIA says to wipe them with a soft, damp cloth after each wear, avoid ultrasonic and steam cleaners, and avoid storing them in plastic. A common habit is to put pearls on last, after perfume, hairspray and lotion, so those products do not build up on the surface.
- After wearing, lay the pearls on a soft cloth.
- Dampen a second soft cloth with plain water.
- Wipe each pearl gently.
- Let the strand dry flat before putting it away.
Opal, turquoise and other sensitive stones
GIA recommends warm soapy water for opal, and lists turquoise as sensitive to heat, acids and chemicals. Keep both away from dips, ammonia and harsh cleaners. Wipe or brush them briefly rather than soaking.
Emerald
Many emeralds are treated with fillers. GIA warns never to put emerald in an ultrasonic or steam cleaner because vibration and heat can make the filler sweat out. Warm soapy water and a soft brush, used gently, is GIA’s safe method.
Garnet, alexandrite and spinel
Per GIA, garnet can go in an ultrasonic but not a steam cleaner, and fracture-filled garnets need extra care. Alexandrite and spinel are generally safe in both. Even so, soap and water works well and avoids any doubt about treatments.
Mixed stones
For a piece with several stone types, clean for the most delicate one. A ring with a diamond and pearls, for example, should be handled like a pearl piece. Our Birthstone Chart lists which stones belong to each month, which helps if you are identifying a gift.
How to clean jewelry by metal
Sterling silver
Under the FTC Jewelry Guides, “Sterling” means at least 92.5% silver. According to the CCI, tarnish is a dark layer made mainly of silver sulfide. The CCI describes silver polishing cloths for light tarnish and a paste of precipitated calcium carbonate and water for heavier tarnish, and warns against multi-purpose metal polishes (too abrasive) and ammonia-containing polishes (which dissolve copper and cause corrosion). Full steps are in our How to Clean Sterling Silver Jewelry and Remove Tarnish guide.
Gold
Gold is commonly described as resisting tarnish better than silver, but it still collects soap film, skin oil and lotion. Warm soapy water and a soft brush is the common method. Karat matters for durability: under the FTC Guides, karat is gold purity in 24ths, so 14K is about 58.3% gold and 18K is 75%. More detail is in our How to Clean Gold Jewelry Safely guide.
Plated, gold-filled and vermeil pieces
Under the FTC Guides, gold plate, gold-filled and vermeil use gold alloy of at least 10 karat, and vermeil is sterling silver coated with gold at least 2.5 microns thick. Because the gold is a layer, a common caution is to avoid polishing cloths and abrasives that could wear through it. Clean with soap and water, a very soft brush and a light touch.
Costume and fashion jewellery
Costume pieces often have glued stones and thin plating. A common method is to wipe them with a barely damp cloth, avoid soaking, and dry immediately so water does not loosen glue or reach the base metal.
How to clean earrings
Earrings need attention because they touch skin closely. A common routine:
- Separate the earrings from their backs.
- Wash posts, hooks and backs in warm soapy water, or wipe them if the stones are delicate.
- Brush the inside of backs gently, where residue builds up.
- Rinse, then dry each part thoroughly.
- Store pairs together so backs do not go missing.
The American Academy of Dermatology notes that earrings and earring backs are among the biggest culprits for nickel allergy, and suggests nickel-free or hypoallergenic metals for people who react. Browse styles in our Amazon Earrings guide.
What to avoid
- Ultrasonic and steam cleaners on any stone GIA lists as unsafe, or on any stone you cannot identify.
- Ammonia-containing polishes on silver, per the CCI.
- Multi-purpose metal polishes on silver, which the CCI calls too abrasive.
- Silver dips on hollow pieces or by full immersion, per the CCI.
- Chlorine bleach and harsh household cleaners, a common caution for metals and stones.
- Mixing cleaning chemicals of any kind.
- Hot water on heat-sensitive stones such as turquoise.
Storing jewellery between cleanings
- Keep softer stones such as opal and garnet apart from harder gems like diamond, sapphire and ruby, which GIA says helps avoid scratches.
- Store silver in sealed polyethylene bags with acid-free tissue, as the CCI suggests, with silica gel to absorb moisture.
- Do not store pearls in plastic, per GIA. A soft fabric pouch is a common alternative.
- Use a lined, divided box, such as a Jewelry Box Organizer With Compartments on Amazon, so pieces do not rub together.
Top-selling match on Amazon
- Jewelry And Watch Box: With 2 removable pillows in the top layer, you can store not only your jewelry but…
- Elegant: Attractive appearance with faux leather surface and soft velvet lining. Over…
- Perfect Gift: The lid has a ribbon attached to keep it from falling back, mirror makes it easier…
Cleaning thrifted and vintage jewellery
Secondhand jewellery can be a great find, as our Thrift Store Jewelry Finds and Jewelry Box Thrift Store Haul pieces show. Before cleaning, look for stamps such as 925, Sterling, 14K or 18K, check for loose stones or worn prongs, and assume any stone you cannot identify is delicate. Start with a dry wipe, then soap and water, and only move to anything stronger once you know the materials. Old glued settings in costume pieces can loosen if soaked.
Shop the look on Amazon
Everything you need to build a secondhand-style wardrobe, delivered. We may earn a commission on purchases.
FAQ
What is the safest way to clean jewelry at home?
Warm water, mild soap and a soft brush. GIA names it as the safe method for many stones, including emerald, opal, moonstone, peridot, tourmaline and tanzanite.
Can I put all my jewellery in an ultrasonic cleaner?
No. GIA says never to use ultrasonic or steam cleaners on emerald, opal, pearl, moonstone, peridot, sardonyx, turquoise, tanzanite or zircon.
How do I clean pearls?
GIA advises wiping them with a soft, damp cloth after each wear, avoiding ultrasonic and steam cleaners, and not storing them in plastic.
What is a good homemade jewelry cleaning solution?
A bowl of warm water with a drop of mild dish soap is the common homemade option. Avoid ammonia on silver, per the CCI.
How often should I clean my jewellery?
There is no fixed rule. Pieces worn daily, such as rings and earrings, benefit from a gentle wash whenever they look dull.
Is it safe to clean jewellery with toothpaste?
None of the sources used here recommend it, and a common caution is that toothpaste can be abrasive. Soap and water is the gentler choice.
Can you clean jewelry with vinegar?
Vinegar is a poor choice for most jewelry because it is an acid, and several stones react badly to acids. GIA lists turquoise as sensitive to heat, acids and chemicals, and soft, organic pearls and opals are also best kept away from it. Acids can also attack plating and the glue in costume pieces. Warm water with a drop of mild dish soap and a soft brush cleans most pieces safely, with a silver polishing cloth for tarnished sterling.